Hydrastar Gasket to suit 1200psi and 1600psi Hydrastar models

Hydrastar Gasket to suit 1200psi and 1600psi Hydrastar Electric controllers are not submersible. Accidents happen, and replacement gaskets and circuit boards are available.

Beware of perished gaskets.

Old gaskets can be almost impossible to remove. You are quite fortunate if you remove the gasket intact and without damage.

When relacing the circuit board, it is a good idea to replace the gasket also.

This Hydrastar gasket suits the new Australian version Generation 7 models and also fits all previous versions and fits

• Hydrastar 1200psi
• Hydrastar 1600 psi

DIY install. Make a drawing of the terminals and where they are located. Remove spade terminals, and remove the circuit board from the housing.

Install wires onto the new circuit board and reinsert them inhousing.

Please ensure all of your gaskets are clean before applying gasket seal and reseal housing onto the body.