60mm Steel Rocker Roller Bush

60mm Steel Rocker Roller Bush is an essential replacement part where the ID is worn or the OD has reduced in size enabling the spring to jump on the roller.

The bush must be 59mm wide with an ID of 16mm. (known as a 60mm bush).

60mm rocker roller spring made by Al-ko and other manufacturers all use a 60mm bush.

We no longer sell plastic rocker roller bushes due to load failure in many cases. Use this bush to replace plastic 60mm roller bushes.

The metal bush carries loads up to 1125kg for 4.5t suspension systems.

Specifications

1. ID: 16mm
2. OD: 35mm
3. Length: 59mm

When installed correctly this 60mm bush must roll freely between the front and back of the rocker spring eyelet.

Some installers like to install hangers on a piece of angle iron (see photo below). How to install rocker roller springs

1. Layout a piece of angle iron
2. Tack weld the centre bracket into position.
3. Bolt the rocker roller complete set into the centre bracket.
4. Stretch the front spring as far as possible and clamp, then tack weld.
5. Repeat for the rear spring.

Note: There is a problem if your rocker roller spring looks different from the above image.

Purchase associated trailer parts are

• 45mm Spring Bushes
• 18mm x 100mm HT Rocker Roller Center Bolt
• 19mm x 75mm HT Rocker Roller Center Bolt