10-inch Offroad Electric Backing Plate Brake Assembly incl Park

10-inch offroad electric backing plate Assembly incl Park - Maximum rating 1600kg.

Premium backing plates are one of the best, most reliable brakes available. Additionally, they are made for Australian conditions.

Complete replacement of backing plates is often a better option than replacing worn components.

You may be unaware of other parts in your backing plate that are near the end of life. Replacing an entire backing plate is a relatively easy procedure.

This electric backing plate is used on slimline and parallel 10" brake drums.

Note: When installing it is important that the park brake is at the 12 o'clock position

Magnets for these backing plates.

• Off-Road Magnets. (left hand and right hand)

We recommend an off-road magnet if you plan to drive over corrugated roads for any length of time.

Four types of electric backing plates

• Standard - Horizontal Park Brake
• Off-road - Horizontal Park Brake
• Dexter Standard - non-genuine
• Dexter Off-road - non-genuine (note: Off-road Magnets installed by Couplemate as required)

It might surprise you to find out that not all 10-inch electric brake backing plates are the same.  Inferior quality backing plates generate excess heat; as a result, they cause overheated bearings and grease.

Review a full list of electric brake parts below:

• 10-inch Electric Backing Plate
• 10-inch Dexter Off-road Backing Plates
• 12-inch Electric Backing Plate
• 12-inch Off-Road Electric Backing Plate
• Dexter 12-inch Aftermarket Electric Backing Plate
• 10-inch Electric Brake Magnet
• 10-inch Off-Road Brake Magnet
• 12-inch Electric Brake Magnet
• 12-inch Off-Road Brake Magnet

What are the features?

• A quality 10-inch electric backing plate
• Suit highway or off-road 1450kg or 1600kg caravans
• Long haul braking.
• The right side is the driver's side.
• Install the electric park brake lever to the top.

The driver's side is the right-hand side. Parking brake levers installed on the bottom will be permanently engaged brakes in a forward motion.

Further, the shoes on electric brakes are not self-centring.

• The parking brake facing at noon ensures the shoes are parallel with two outcrops on the backing plate located at 3 and 9 o'clock.
• Tap the shoes into position until they are perfect.

Finally, use 4 x 7/16" UNF nuts to bolt the backing plate to the weld ring.

10-inch Electric Backing Plate Brake Kit