Off-Road Brake Magnet 10 inch and 12 inch

$32.00$35.00 inc GST

Clear
Add to Wishlist
Add to Wishlist
SKU: CM737 Category:

Offroad Electric Brake Magnets

Off-road brake magnets are suited to caravan and camper trailer all-electric brake systems except for older round magnet brake systems.

How to check off-road brake magnet wear

  • Check the four small holes on top of the magnet.
  • These holes are warning indicators that display magnet wear.
  • Extreme magnets wear if there are no holes or fewer than four holes.
  • When the face of the magnet hole has worn, then it is time to replace the magnet.

Key Features

  • Wear holes are at 3 pm, 6 pm, 9 pm and 12.
  • Magnets draw approximately 3.2 amps each
  • Wires can be connected either positive or negative.

Once worn, copper begins to become exposed. Subsequently, an open electric circuit will render the brakes inoperable.

TIP:

  • Bed new magnets into position to achieve 100% braking efficiency.
  • The magnet face is a shiny finish.
  • This finish needs to be scuffed up during the initial stages of breaking before your magnets become 100% effective.

Note: no spring is provided, please use the existing spring. The rubber band hold the magnet in position until the first braking event. Offroad magnets do not require holding clips.

Review Replacement Backing Plates

Additional information

Weight 0.4 kg
Dimensions 3 × 5 × 10 cm
Select Size and Side

10-inch Passengers, 10-inch Drivers, 12-inch Passengers, 12-inch Drivers

Reviews

There are no reviews yet.

Be the first to review “Off-Road Brake Magnet 10 inch and 12 inch”

Your email address will not be published.